Mopar Insiders Forum

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Replacing Cam Shaft position and the crankshaft position sensor

lwlambert

New member
Joined
Jul 24, 2018
Messages
18
Reaction score
6
Hello everyone. Narrowing my repair down on the PO 108, PO300 , and the PO308. Just bought the two sensors I mentioned above. About to crawl under the jeep and try and locate the two and attempt to replace both of them. Any advice as to the location or best way to getr to them. I think I need a 10 mm or 11 mm socket. Larry
 

Users who are viewing this thread

Top